Powering On the Mini Lite
To power on the Mini Lite, plug the charging cradle directly into a wall outlet. (In order to ensure the cradle is receiving sufficient power avoid power strips, extension cords, and outlets controlled by a light switch.)
When the charging cradle is plugged in and receiving power, a red LED light in the center of the cradle will illuminate.
Line up the device with the cradle and push down until you hear a click.
If the device was cradled properly, it will state “charging”.
The call button will flash red while charging.
Powering Off the Mini Lite (Reset Button)
The rest button is located on the back of the device and can be used to power off the device or put it in sleep mode.
Activate by pressing and holding the button for 3 seconds with the tip of a pen.
If successful, it will state, “Powering off. To power back on, press the SOS button or place it on the charging cradle.”
TIP: A second button press is required to make a call after pressing the button to turn it back on.
Sleep Mode
- A short press (less than a second) of the reset button will put the device into sleep mode.
- This action will terminate a call if pressed when the call is in progress.
- Fall detection and other motion reports are disabled when in sleep mode.
- To exit sleep mode, press the call button or place the device on the charging cradle.
